Towards Solving the Conundrum of Fast-Spread Ocean Crust Formation: Insights from Textural Analysis of Gabbroic Rocks from Pito Deep and Hess Deep, East Pacific Rise
Abstract:
PD gabbroic rock textures are consistent with a gabbro glacier flow model generating the uppermost plutonic crust. Shallow samples (41-72 mbsd) likely formed at the distal edge of the magma lens, analogous to similar rocks from Oman. These gabbros are relatively evolved (cpx Mg#75-77, An53-61 and 1-4% Fe-Ti oxides), and have elongate plagioclase grains (aspect ratios up to 1:2:10) exhibiting a strong shape preferred orientation (SPO) with <40% of grains showing dislocation creep textures. Deeper samples (177-876 mbsd) likely began crystallizing in the magma lens then subsided and ‘flowed’ through the underlying mush zone. These gabbros are more primitive below 386 mbsd (Fo83-88, cpx Mg# 85-89 and An70-82), and plagioclase grains have more equilibrated morphologies (aspect ratios < 1:2:6) that define ~vertical SPOs which increase in strength with depth. Plagioclase exhibits magmatic crystal-lattice preferred orientations (CPOs) which are also vertical. Significantly, the proportion of grains showing dislocation creep textures increases with depth, and plagioclase grain size distributions show a smaller range of sizes at depth; observations that perhaps reflect the effect of increasing strain with depth.
IODP Hole U1415I at HD recovered gabbros and troctolitic gabbros from the mid lower crust that show distinctive cm-dm scale modal layering. Strong plagioclase SPOs parallel layering and magmatic CPOs vary dramatically in strength over just 4.5 m of core. Plagioclase grains are relatively equant (aspect ratios < 1:2:4), wrap around large cpx oikocrysts, and exhibit fewer dislocation creep textures than the PD gabbros. These observations perhaps suggest primary crystal accumulation rather than bulk strain/flow. The similar mineralogy and textures of these samples to those from the Rum layered intrusion suggest HD U1415I gabbros may have formed by mid-crust sill injection.
