| Modifying Bandgap of Tio2-Based Nanoparticles by Cation Doping | ||
| Wey Yang Teoh, School of Chemical Engineering and Industrial Chemistry, ARC Centre for Functional Nanomaterials, University of New South Wales, Sydney, 2052, Australia, Lutz Maedler, Chemical Engineering, UCLA, 405 Hilgard Avenue, 5531-G Boelter Hall, Los Angeles,, CA 90095, Rose Amal, ARC Centre for Functional Nanomaterials, University of New South Wales, Sydney, 2052, Australia and Sotiris Pratsinis, Swiss Federal Institute of Technology (ETH Zurich), Department of Mechanical & Process Engineering, Sonneggstrasse 3, ML F26, Zurich, CH-8092, Switzerland Doping of foreign elements is a common practice in modifying the bandgap of semiconductors. This is especially important in photocatalysis where undoped TiO2 can only be activated by light energy equal to or greater than 3.2 eV i.e. ultraviolet. Such energy range is unfortunately present in less than 3% of the solar spectrum. In this work, attempts to synthesise cation-doped (Fe, V, Mn and Co) TiO2 with bandgap energy less than 3.2 eV is demonstrated via a one-step Flame Spray Pyrolysis technique. Doping cations into TiO2 lattice creates impurity energy level in the original bandgap hence allowing for photoresponse at lower energy or by visible light. The amount of each dopant was varied between 0.5 to 30 atom% and its effects on the bandgap energy and other physicochemical properties were investigated. Extended Abstract Status: Not Uploaded | ||